ASE A3 Manual Drive Train and Axles
21. The bushing in a transmission's extension housing is worn on one side only. Technician A says binding universal joints cause this type of wear. Technician B says this is caused by excessive output shaft endplay. Who is correct?
- A. Technician A
- B. Technician B
- C. Both A and B
- D. Neither A or B
22. A chirping sound is heard from the transmission bellhousing when the clutch pedal is depressed. Which of the following is MOST likely causing this noise?
- A. A Synchronizer Assembly.
- B. The Clutch Disc.
- C. The Input Shaft Bearing.
- D. The Release Bearing.
23. Technician A says to use a feeler gauge to check the clearance between the shift fork and the synchronizer sleeve. Technician B says a bent shift rail will cause hard shifting. Who is correct?
- A. Technician A
- B. Technician B
- C. Both A and B
- D. Neither A or B
24. Two technicians are discussing a clutch pressure plate. Technician A says to replace the pressure plate if it's warped. Technician B says the pressure plate can be easily disassembled, repaired, or resurfaced. Who is correct?
- A. Technician A
- B. Technician B
- C. Both A and B
- D. Neither A or B
25. Technician A says to replace the ring gear without replacing the pinion gear as long as it's within specifications. Technician B says to check the ring gear runout with a digital micrometer. Who is correct?
- A. Technician A
- B. Technician B
- C. Both A and B
- D. Neither A or B